Everything below concerns secondary drying. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Last reviewed on 2026-03-29. Where a claim depends on a specific study, the study is described rather than over-claimed.
The low pressure used during drying allows water vapor to move from the ice surface to a cold condenser. Energy supplied as heat drives sublimation but must stay below the collapse temperature of the frozen matrix. If the product becomes too warm, the frozen structure may soften or melt, reducing pore formation and slowing drying. Formulations often include bulking agents, stabilizers, or buffers to support a rigid cake. The final moisture content depends on formulation, freezing rate, and the length of secondary drying.
Freeze-drying is distinct from simple evaporation and from spray drying. Evaporation removes water at temperatures above freezing, while spray drying rapidly dries droplets in a heated gas stream. Lyophilization avoids high temperatures, which can be useful for heat-sensitive materials such as proteins, vaccines, and some foods. The porous cake produced by sublimation dissolves or rehydrates more quickly than a dense dried mass. Not all materials tolerate freezing or the pH shifts that can occur as solutes concentrate during ice formation.
Stability of a lyophilized solid depends on water content, temperature, and the physical state of the formulation. Amorphous products may slowly absorb moisture and drop below their glass transition temperature, causing collapse or crystallization. Some proteins and peptides can aggregate even in a dry state, especially when exposed to heat or moisture. Accelerated stability studies at elevated temperature and humidity help estimate shelf life, but real-time data remain the basis for expiration dating.
After drying, a lyophilized product is usually sealed under vacuum or an inert gas to limit moisture and oxygen exposure. The container closure system matters because stoppers and seals can allow moisture ingress over time. Storage conditions are selected from stability studies that track potency, cake appearance, and reconstitution behavior. Many freeze-dried materials are kept at controlled room temperature, while some require refrigeration or protection from light.
| Property | Value | Notes |
|---|---|---|
| Primary phase change | Sublimation | Ice changes directly to vapor under reduced pressure |
| Typical chamber pressure | 0.01–0.5 mbar (1–50 Pa) | Below the triple point of water; product-specific |
| Typical product temperature during primary drying | −40 °C to −10 °C | Kept below collapse temperature |
| Typical residual moisture | 0.5–3% w/w | Target range varies by formulation and use |
| Common synonyms | Freeze-drying; lyophilisation | Lyophilization is the US spelling |
Freezing is the first stage and sets the ice structure that later becomes the pore network. The formulation is cooled below its freezing point, often with a controlled ramp, and solutes concentrate as ice forms. Primary drying then lowers chamber pressure and supplies heat to sublime the ice. The product temperature must stay below its collapse or eutectic temperature to prevent structural loss. Secondary drying raises the temperature modestly to remove bound water and achieve a low residual moisture.
A freeze-dryer consists of a vacuum chamber, temperature-controlled shelves, a condenser, and a vacuum pump. Vials, ampoules, or bulk trays hold the product during the cycle. The condenser traps water vapor as ice at a temperature lower than the product. Cycle development balances shelf temperature, chamber pressure, and time. Scale-up can be difficult because heat and mass transfer change with equipment size, so process analytical tools and conservative validation are often used.
Analytical methods for lyophilized materials include X-ray diffraction for crystallinity, differential scanning calorimetry for thermal transitions, and scanning electron microscopy for pore morphology. Moisture sorption analysis shows how the cake responds to humidity. These methods help distinguish amorphous from crystalline states and detect phase changes. Open questions remain about how pore structure changes during long-term storage and how best to predict collapse under varied conditions. Comparisons across studies are complicated by differences in formulation, cycle, and storage history.
Quality control for lyophilized products focuses on appearance, moisture level, reconstitution time, and structural integrity. A cake should be uniform, intact, and free of meltback or collapse. Moisture level is measured by Karl Fischer titration or thermogravimetric analysis. Reconstitution time reflects pore structure and formulation. Visual inspection and vial integrity checks detect cracks, stopper defects, or particulate matter. These checks are often performed on samples from each batch. They help confirm that the drying cycle performed as intended.
The physics of lyophilization depends on phase boundaries and heat and mass transfer. During primary drying, heat supplied to the product must equal the latent heat of sublimation, while water vapor moves through the drying cake to the condenser. If shelf temperature or pressure is set too high, the ice front can exceed the collapse temperature, causing meltback or pore collapse. If conditions are too cold, drying slows and costs rise. Formulation excipients, vial geometry, and freezing rate alter these limits.
Equipment for lyophilization includes a vacuum chamber, temperature-controlled shelves, a condenser, and a vacuum pump. A refrigeration system cools the shelves and condenser below the product's freezing point. Process monitoring often uses Pirani and capacitance manometers, thermocouples, and resistance sensors. Cycle development balances product quality with time and energy use. Some products are annealed during freezing to improve crystallization of bulking agents. Open questions remain about scaling cycles between laboratory, pilot, and production freeze-dryers.
In a clinical trial, the group that does not receive the new treatment being studied. This group is compared to the group that receives the new treatment, to see if the new treatment works. (NCI) The standard by which experimental observations are evaluated. In many clinical trials, one group of patients will be given an experimental drug or treatment, while the control group is given either a standard treatment for the illness or a placebo (NLM) Controlled clinical trial
In presence of a β-hydrogen, a selenide will give an elimination reaction after oxidation, to leave behind an alkene and a SeO-selenoperoxol. The SeO-selenoperoxol is highly reactive and is not isolated as such. In the elimination reaction, all five participating reaction centers are coplanar and, therefore, the reaction stereochemistry is syn. Oxidizing agents used are hydrogen peroxide, ozone or MCPBA. This reaction type is often used with ketones leading to enones. An example is acetylcyclohexanone elimination with benzeneselenylchloride and sodium hydride.
Dipipanone, sold under the brand names of Pipadone and Diconal is a strong opioid analgesic drug, used for acute pain by mouth (PO) for adults. It is often used in instances where morphine is indicated but cannot be used due to the patient being allergic to morphine. In analgesic potency 25 mg dipipanone is approximately equivalent to 10 mg morphine.
Naturally occurring tellurium on Earth consists of eight isotopes: 120, 122-126, 128, 130. The heaviest two have been found to be radioactive: 128Te and 130Te undergo double beta decay with half-lives of, respectively, 7.7×1024 years (the longest half-life of all nuclides proven to be radioactive) and 7.9×1020 years. Artificial radioisotopes of tellurium are known, with atomic masses that range from 104 to 142, of which the most stable is 121Te with a half-life of 19.31 days. Several nuclear isomers have longer half-lives, the longest being 121mTe with a half-life of 164.7 days. The very long-lived radioisotopes 128Te and 130Te are the two most common isotopes of tellurium. Of elements with at least one stable isotope, only indium and rhenium likewise have a radioisotope in greater abundance than a stable one. It has been claimed that electron capture of 123Te was observed, but more recent measurements of the same team have disproved this. They have determined the half-life of 123Te to be longer than 9.2 × 1016 years (or 2 × 1015 years without any theoretical assumptions). Its observational stability presents one of only two apparent violations of the Mattauch isobar rule, the other involving 180mTa. 124Te is used as the starting material in the production of certain radionuclides by a cyclotron or other particle accelerator, such as iodine-123 and iodine-124. With the exception of beryllium, tellurium is the lightest element observed to have isotopes capable of undergoing alpha decay, with isotopes 104Te to 109Te being seen to undergo this mode of decay.
Hundreds of cocaine analogs have been created, all of them usually maintaining a benzyloxy connected to the 3 carbon of a tropane. Various modifications include substitutions on the benzene ring, as well as additions or substitutions in place of the normal carboxylate on the tropane 2 carbon. Various compound with similar structure activity relationships to cocaine that aren't technically analogs have been developed as well.
Sources: en.wikipedia.org
Colin Shindler, first professor of Israel Studies in the UK; founding chairman of the European Association of Israeli Studies (EAIS); author of ten books including History Of Modern Israel(Cambridge University Press); main interests lie in evolution of Israeli Right, changes in the approach of the British and European Left towards Israel since 1948 and emigration movement of Soviet Jews between 1917 and 1991; Israel and the European Left: Between Solidarity and Delegitimisation (Continuum/Bloomsbury) was one of first books to examine history of relationship between the British Left and Israel; also wrote Vladimir Jabotinsky, Menahem Begin and Avraham Stern, The Rise of the Israeli Right: From Odesa to Hebron (Cambridge University Press) which was awarded gold medal in The Washington Institute's for Near East Policy's Book Prize competition; writes for the Jewish Chronicle, Jerusalem Post, Haaretz, History Today, Times Literary Supplement; author of over 650 articles and reviews on Israel and Jewish political history. Avi Shlaim, writer, of Iraqi Jewish and Mizrahi Jewish origin; his work focuses on Zionist settlement of the land of Palestine, history of the Nakba and dispossession of Palestinian land. He is one of Israel's New Historians, a group of Israeli scholars who put forward critical interpretations of the history of Zionism and Israel.
== History == The founding meeting for the CSCC was held in Montreal, Quebec on October 17, 1956. Since that time, the membership has grown to several hundred clinical chemists. In 1986 the Canadian Academy of Clinical Biochemistry was established as the academic body of the CSCC to oversee training, certification, accreditation, and professional development of clinical chemists in Canada. A syllabus for post doctoral training in clinical biochemistry was developed and is maintained by the CACB as a guide to program directors and trainees. The CSCC holds an Annual Scientific Congress and Annual General Meeting. The 61st annual CSCC conference was held in San Diego, CA, USA from July 31-August 4, 2017 as a joint meeting with the AACC.
Based on evidence from the geologic record, life most likely emerged on Earth between 4.32 and 3.48 Gya. In 2017, the earliest physical evidence of life was reported to consist of microbialites in the Nuvvuagittuq Greenstone Belt of Northern Quebec, in banded iron formation rocks at least 3.77 and possibly as old as 4.32 Gya. The micro-organisms could have lived within hydrothermal vent precipitates, soon after the 4.4 Gya formation of oceans during the Hadean. The microbes resemble modern hydrothermal vent bacteria, supporting the view that abiogenesis began in such an environment. Later research disputed this interpretation of the data, stating that the observations may be better explained by abiotic processes in silica-rich waters, "chemical gardens," circulating hydrothermal fluids, or volcanic ejecta. Biogenic graphite has been found in 3.7 Gya metasedimentary rocks from southwestern Greenland and in microbial mat fossils from 3.49 Gya cherts in the Pilbara region of Western Australia. Evidence of early life in rocks from Akilia Island, near the Isua supracrustal belt in southwestern Greenland, dating to 3.7 Gya, have shown biogenic carbon isotopes. In other parts of the Isua supracrustal belt, graphite inclusions trapped within garnet crystals are connected to the other elements of life: oxygen, nitrogen, and possibly phosphorus in the form of phosphate, providing further evidence for life 3.7 Gya.
Aside from adult transgender people, CPA has also been used as a puberty blocker and hence as an antiandrogen and antiestrogen to suppress puberty in transgender adolescents, although GnRH modulators are primarily used and more effective for this purpose.
Sources: en.wikipedia.org
Lyophilization relies on sublimation, so water moves from solid ice to vapor without becoming liquid. The material is frozen, pressure is reduced, and controlled heat is supplied. Vapor is captured on a cold condenser, leaving a dry porous solid.
The process has three main stages: freezing, primary drying, and secondary drying. Freezing sets the ice structure, primary drying removes free ice, and secondary drying removes bound water. Each stage uses specific temperature, pressure, and time settings.
No, it is a drying method rather than a sterilization method. Removing water can limit microbial growth, but it does not reliably kill microorganisms. Sterility must come from separate steps such as filtration, heat treatment, or aseptic processing.
Sealed vials or containers should be kept at the temperature specified by stability data, often controlled room temperature or 2–8 °C. Moisture and oxygen barriers are important because both can degrade sensitive materials. Opened containers may need immediate use or protection from ambient humidity.